Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

NE5

Silca key blank for ignition key, match profile to your existing key

 This part is due back in stock soon, call 01484 841395 to reserve yours

Kit containing two replacement 60cm silicon HT leads, lead ends and 90° plug caps. The leads are suppied as a single double length lead so you can cut it into two leads of the exact required length. Includes crimp on lead ends for standard big twin 12v round coils

Suitable for most models with coils under the tank where the HT lead is not moulded into the ignition coil. We recommend checking what type of plug cap you have and measuring your existing cable run to check this part will fit

 This part is due back in stock soon, call 01484 841395 to reserve yours

One metre of copper core HT lead, this is superior to the more commonly available carbon core lead

Sold by the metre, one metre is enough for two leads on most models with coils under the fuel tank. For models with coils under the side panel you will need two metres. See ELA14715 and ELA14714 for plug caps and ELA20001 for coil screw cap. See ELA00001 for crimp on HT lead connector

 More than 5 in stock

Crimp on HT lead connector, also used on loop frame distributors

We recommend checking your bike uses this type of connector before purchasing

 More than 5 in stock

Factory heated grip kit to keep your hands toastie warm all year round. Three heat levels, integrates with the V85 TT wiring and TFT dashboard. The grips are switched on by a button on the left hand switchgear. Fully compatible with fly by wire (unlike aftermarket grips).

Includes a complete heated twistgrip, heated grip for the clutch side and fitting instructions. The thottle has to be calibrated at an official Moto Guzzi dealer with the factory software after installation.

 This part is available by special order, request a quote

2S001325

Insulated medium female spade connector for 6.3mm male terminals

Crimp type

 More than 5 in stock

Insulated large female spade connector for 9.5mm male terminals

Crimp type

 More than 5 in stock

Insulated medium female bullet connector

Crimp type

 More than 5 in stock

Domino left hand switchgear with lights on - park - off, high and low beam, pass, indicator and horn switches. Same style switch as ELA01738.

Already wired in to 9 pin block connector (you may need to alter the wiring on your bike to correspond to this block connector). Originally fitted as standard to early V11 Sport models. See the wiring diagram on our technical documents page for help installing this switchgear. See Greg Bender's website for a custom sub-loom that enables easy fitting of this part to models previously fitted with LEGO style swithgear

 This part is due back in stock soon, call 01484 841395 to reserve yours

 01738030 GU01738030 01 73 80 30
 0173 8030 0173.8030 01.73.80.30